Coil Winder Disc - 2nd Shift

The Coil Winder role is a heavy assembly position that focuses on the assembly of our coil windings. In this position you would train to set up and wind medium and large power 1 and 2 wire disc windings, multiple disc windings from 1 to 16 wires, and screw and RV windings.

• Receive assignments and instructions from supervisor - both verbal and written. Follows drawings, Bill of Materials, and other established manufacturing procedures. Coordinate and communicate with supervision and team leads
• Assemble material at work place.
• Assemble components to cylinder
• Perform machine and material set up
• Load cylinder to machine.
• Wind coil as per specs.
• Verify accuracy of winding per in-process checklist
• Unload and upend coil and position end assembly as required.
• Assist others with their windings
• Perform minor repairs and machine maintenance. Write repair work orders as required.
• Repair coil in any department or work center.
• Keep tools, equipment and work place neat and orderly
• Manually bend leads
• Brazing of conductor
• Perform other work as required
• Assist in training of new operators.

• Knowledge of winding machine, overhead crane, brazing equipment, dereeler, upender, hand drill, disc sander, lead clamping and bending equipment, bar clamping equipment, table and bandsaw, hydraulic bender, torch set, grinder, buffer and miscellaneous hand tools.

• Materials used in this position include copper conductor, pressboard, emery cloth, paper insulation, glue, copoco paper, sil-foss and cloth tape.

This role works under general supervision. Work is precision in nature and therefore is both mentally and visually demanding. Individual is responsible for own work which is not readily inspected by others. Individual must have thorough knowledge of winding techniques and the ability to visualize the consequence of his workmanship across the total product.

Required Education / Experience

• High School Diploma or equivalent

Key Working Relationships

• Plant Supervision, Quality, Planning, etc.
• Engineering Organization, including mechanical, electrical and manufacturing engineering groups

Physical Demands

Must be able to stand for extended periods of time. Must be able to occasionally sit, walk, climb, balance, push, pull, bend, twist, carry, work below waist level, and foot use.

Working Conditions

Shop-floor located on large manufacturing plant.

Prolec-GE Waukesha, Inc. is an equal opportunity employer and makes employment decisions without regard to race, color, religion, national origin, sex, sexual orientation, gender identity, age, genetic information, disability, protected veteran status, or any other reason prohibited by applicable law.